Posted on

how to plant weed seeds step by step

Perhaps the most exciting stage, your baby will typically come above ground in 1-2 weeks. As your seedling comes above the soil, its shell might take a few days to fall off. It’s best to leave it alone, nature has the job covered. If it does not come above ground after about two weeks, the chance of success is dramatically reduced, and it’s best to try again. Even the best seeds have an 85% germination rate. When your seedling comes above ground, it is going to want to see a direct light source.

Our favorite thing about starting from a seed, rather than a clone, is that you get to see the full life cycle and enjoy a plant that is unique, just like you. An entirely new genetic makeup will enter the world for the first time, and if you’re lucky, something remarkable might be born.

We like to use seedling pellets that are made of a mix of compressed peat moss and coco husk. To expand, soak it in water for 10 minutes. Once your seedling pellet has absorbed enough water and has expanded to its maximum size, drain off any excess water. The growing medium should be like a damp sponge that would not leave streaks on the table. Dig a small hole about 1/4 in deep for your seed. Use a spoon to lift the seed out of its bath. If it has popped out a taproot be careful not to damage it. Gently place the seed into the hole and lightly cover it with dirt from the pellet. Now that you have started the germination process, your seedling will come above ground within two weeks. The older the seed, the longer it takes for it to germinate.

3) Above the ground

Raising a seedling, however, requires some patience, gentle hands, and a smidgen of luck. Thankfully pot seeds are remarkably vigorous because they are what’s called endosperm seeds, which means they have almost pre-formed cotyledon leaves before you even add water. Below is a brief guide on the techniques we have found yield the most success when starting seeds and raising your seedling to a healthy plant ready for transplanting.

To accelerate germination, you are going to want to soak your seed in a small container with lukewarm water and place it in a dark and warm place for 12-24 hours, but no longer. By drenching the seed, it absorbs the water thoroughly, activating the germination process. Doing this also helps to loosen the shell as it becomes a little softer making it easier for the embryo to crack it open. When your seed sinks to the bottom it is ready to be planted, and sometimes the seed will pop out a small taproot. A seed can still be planted though if it does not sink.

Seedlings require a medium amount of light in which it has enough to grow but not too much light that it gets burned. Leaving your seedling in direct sunlight will cause the leaves to curl, while too little light will cause the seedling to stretch. If growing outside, seedlings want to see a direct light source to stop them stretching. If inside, a sunny windowsill with more than half a day of sunlight works wonders. Otherwise, 18 in away from a growing light works excellently. Your seedling should not stretch more than 6 in at most. We’ll cover lighting in more depth in a later blog.

Starting from seed is a remarkable journey. Understanding the biology is one thing, but comprehending how a little miracle bean can turn into a gigantic tree that can affect your body and mind is nothing short of an evolutionary miracle. Or rather a co-evolutionary story of plant and human.

Cannabis seeds require three things to germinate: water, heat, and air. There are many methods to germinate seeds, but for the most common and simplest method, you will need:

Some varieties of cannabis can produce male parts alongside female flowers on the same plant, especially if exposed to environmental stressors. These plants are known as hermaphrodites, and sometimes they can self-pollinate to create seeds.

Remember, once a seed germinates, the real work begins. Sexing, selecting, vegetative growth, flowering, and the eventual harvest all lie ahead.

What are high-CBD cannabis seeds?

This is the beauty of seeds—often, you can tell which plants or genetics will thrive right from the get-go. This will help you determine which plants you want to take cuttings from for clones or for breeding if you want to create a seed bank of your own.

Because training happens during vegetative growth, for autoflowering plants, this period could be as short as a few weeks, which means time is limited. Try topping your autoflowers after they have three nodes, and stop once they begin to flower. You will want to prune them lightly.

Autoflowers don’t need lots of nutrients because they’re small and don’t spend much time in the vegetative cycle. They won’t need as much veg nutrients—such as nitrogen—but will need more bloom nutrients.

It’s important to keep the delicate seed sterile, so don’t touch the seed or taproot as it begins to split.

This article was co-authored by our trained team of editors and researchers who validated it for accuracy and comprehensiveness. wikiHow’s Content Management Team carefully monitors the work from our editorial staff to ensure that each article is backed by trusted research and meets our high quality standards.

This article has been viewed 1,134,113 times.

Related wikiHows

Growing cannabis at home can be a fun project and a nice way to have your own cannabis plants on hand. You may want to grow cannabis indoors due to inclement weather in your area or due to a lack of green space in your yard. Start by germinating the seeds. Then, plant the seeds in soil or in a starter cube. Once the seeds have been planted, care for them properly so they grow and thrive.

wikiHow marks an article as reader-approved once it receives enough positive feedback. In this case, 95% of readers who voted found the article helpful, earning it our reader-approved status.

To plant cannabis seeds indoors, first soak the seeds in lukewarm tap water for 12 hours. Discard any seeds that float to the top. Then, place the seeds on a damp paper towel on a plate with 1 inch (2.5 cm) of space between each seed. Cover the seeds with another damp paper towel. Keep the seeds in a spot that remains between 70-80°F (21-27°C), and spray the paper towels with water whenever they start to dry out. The seeds will sprout in 2-3 days. When they do, fill pots or a growing tray 3/4 of the way with loose potting soil that has a pH between 5.8 and 6.3. Press the soil down lightly, leaving some air in it. Then, use a pencil to poke 1 inch (2.5 cm) holes in the soil. Place the sprouted seeds vertically in the holes and fill the holes with potting soil. Water the soil thoroughly and place the pots or tray in a spot that’s always 75°F (24°C) or warmer. Set up a grow light over the seeds and leave it on at all times. Water the seeds every day so the soil doesn’t dry out. The seedlings will emerge in 2-4 weeks. To learn how to use cool white grow lights to help your cannabis seeds grow, keep reading!