Posted on

how to grow good weed from regular seeds

Seedlings require a medium amount of light in which it has enough to grow but not too much light that it gets burned. Leaving your seedling in direct sunlight will cause the leaves to curl, while too little light will cause the seedling to stretch. If growing outside, seedlings want to see a direct light source to stop them stretching. If inside, a sunny windowsill with more than half a day of sunlight works wonders. Otherwise, 18 in away from a growing light works excellently. Your seedling should not stretch more than 6 in at most. We’ll cover lighting in more depth in a later blog.

To accelerate germination, you are going to want to soak your seed in a small container with lukewarm water and place it in a dark and warm place for 12-24 hours, but no longer. By drenching the seed, it absorbs the water thoroughly, activating the germination process. Doing this also helps to loosen the shell as it becomes a little softer making it easier for the embryo to crack it open. When your seed sinks to the bottom it is ready to be planted, and sometimes the seed will pop out a small taproot. A seed can still be planted though if it does not sink.

Starting from seed is a remarkable journey. Understanding the biology is one thing, but comprehending how a little miracle bean can turn into a gigantic tree that can affect your body and mind is nothing short of an evolutionary miracle. Or rather a co-evolutionary story of plant and human.

4) Lighting for your seedling

Perhaps the most exciting stage, your baby will typically come above ground in 1-2 weeks. As your seedling comes above the soil, its shell might take a few days to fall off. It’s best to leave it alone, nature has the job covered. If it does not come above ground after about two weeks, the chance of success is dramatically reduced, and it’s best to try again. Even the best seeds have an 85% germination rate. When your seedling comes above ground, it is going to want to see a direct light source.

We like to use seedling pellets that are made of a mix of compressed peat moss and coco husk. To expand, soak it in water for 10 minutes. Once your seedling pellet has absorbed enough water and has expanded to its maximum size, drain off any excess water. The growing medium should be like a damp sponge that would not leave streaks on the table. Dig a small hole about 1/4 in deep for your seed. Use a spoon to lift the seed out of its bath. If it has popped out a taproot be careful not to damage it. Gently place the seed into the hole and lightly cover it with dirt from the pellet. Now that you have started the germination process, your seedling will come above ground within two weeks. The older the seed, the longer it takes for it to germinate.

Our favorite thing about starting from a seed, rather than a clone, is that you get to see the full life cycle and enjoy a plant that is unique, just like you. An entirely new genetic makeup will enter the world for the first time, and if you’re lucky, something remarkable might be born.

Raising a seedling, however, requires some patience, gentle hands, and a smidgen of luck. Thankfully pot seeds are remarkably vigorous because they are what’s called endosperm seeds, which means they have almost pre-formed cotyledon leaves before you even add water. Below is a brief guide on the techniques we have found yield the most success when starting seeds and raising your seedling to a healthy plant ready for transplanting.

Regular cannabis plants provide strong and healthy clones capable of rooting well and growing fast.

Cloning enables growers to make an exact genetic copy of a specific plant. If you like the morphology or colour of a certain specimen, you can duplicate it through cloning.

BREEDING

It’s possible to tell them apart before plants are mature enough to reproduce. Plants will start to reveal their sex at the tail-end of the vegetative phase.

Enter the male grow space with a plastic bag and place the bag over a branch that contains mature pollen sacs. Shake your plant to release pollen into the bag.

Regular cannabis plants are more suitable for cloning than their feminized counterparts. These clones will be much more stable, possess stronger genetics, and are less likely to become hermaphrodites.

You’re probably thinking: grow plug? Propagator? Root stimulator? What?! No worries: germinating is 100% natural. All cannabis seeds really need is light and water. Check out my preferred germination method here, or follow this grow guide to plant germinated seeds directly into the soil. Find out what works best.

Germinated and planted: your grow is good to go!

Baby Steps: Germinating Your Weed Seeds

A small, cheap USB pocket microscope or a jeweler’s lens are great for determining trichome maturity. Clear transparent trichomes are a sign to wait some more. Once they turn milky white, with a few amber-coloured trichomes among them, you’re ready to cut the flowers. Harvest time is finally here!

After drying, I carefully remove all the buds from the nets and place them in glass mason jars to cure. The buds cure gradually, improving their taste and ‘maturing’ them until they are perfect for smoking. Curing buds is a straightforward affair: simply stick them in a jar and wait. Give them time to ‘burp’, though: open them for a few minutes to refresh the air inside and return them to their dark storage location. How long you cure is matter of personal taste. I personally cure my weed for one month before that sweet day arrives: time to smoke those fabulous Amsterdam Genetics! Let’s not kid ourselves here: this is what we’ve been working so hard for, isn’t it?

Once the seeds become seedlings, with roots showing on the sides and bottom of the grow plus (usually after about four days), they’re ready for planting. I start with small P9 size flower pots. I’ll leave them for 7 to 11 days to give the roots time to develop, creating a stable habitat.